| Input frequency range |
0.01-30 MHz (direct input section), 30-3000 MHz (heterodyne section),
separate SMA inputs, paths internally switchable |
| Tuning resolution |
1 MHz |
| Output frequency |
70 MHz |
| Output bandwidth |
22 MHz |
| Gain |
30 dB typ. |
| Noise figure |
15 dB typ. |
| Internal spurii |
less than -100 dBm of eq. antenna input
except for 30 MHz reference clock at typ. -70 dBm
and its multiples at less than -90 dBm typ. |
| IF rejection |
>40 dB typ. |
| Image rejection |
>40 dB typ. |
| Maximum input level |
+10 dBm |
| Attenuation control |
0-20 dB in 1 dB steps
(30 to 3000 MHz path only) |
| IP3 |
-3 dBm @ 1060 MHz with interfering signals at 1040 MHz and 1050 MHz |
| Input impedance |
50 ohm (SMA connector) |
| Output impedance |
50 ohm (SMA connector) |
| Amplitude ripple |
3 dB typ. |
| Phase ripple |
3 degrees typ. |
| Phase adjustment range |
60 degrees |
| Phase adjustment resolution |
0.25 degrees |
| Channel-to-channel isolation |
40 dB typ. |
| Total phase noise |
-86 dBc/Hz @ 10 kHz offset (30 MHz internal ref.) |
| Tuning speed |
5 ms typ. |
| Frequency stability |
1 ppm (or external reference) |
| External reference |
10 MHz or 30 MHz (-5 dBm to +15 dBm) |
| LO1 |
3950 to 6920 MHz (accessible to the user at 0 dBm +/- 5 dB via SMA LO1 Out) |
| LO2 |
3850 or 3990 MHz (accessible to the user at +5 dBm via SMA LO2 Out) |
| IF1 |
3920 MHz (accessible to the user with 0 dB gain, 30 MHz BW, SMA output) |
| Phase-coherent capability |
Inbuilt two-way splitters on LO1 and LO2 for two-channel phase-coherent operation |
| HF Mode Preselector |
Switchable AM BCB filter |
| HF Mode Preamplifier |
20 dB switchable |
| HF Mode Antialiasing Filter |
30 MHz LPF |
| Power consumption |
6 W typ. |
| Control interface |
USB 2.0 or RS-232C |
| Dimensions |
91 x 68 x 47 mm (3.6" x 2.7" x 1.9") |
| Weight |
375 g (13.2 oz) |
| Operating temperature |
-10º to +60º C |
| Humidity |
20-90% non-condensing |
