WR-G527e/TM Tuner Module
| Input frequency range |
0.01 - 30 MHz (direct input section)
20-3000 MHz (heterodyne section) |
| Tuning resolution |
10 Hz |
| Output frequency |
70 MHz |
| Output bandwidth |
22 MHz |
| Gain |
30 dB typ. |
| Noise figure |
10 dB typ. @ 100 MHz |
| Internal spurii |
Typ. less than -107 dBm of equivalent antenna input level* |
| IF rejection |
>60 dB |
| Maximum input level |
+10 dBm |
| Attenuation control |
0-30 dB switchable front-end attentuator in 2 dB steps,
20 dB switchable attenuator in IF path |
| IP3 |
0 dBm typ. @ 10 kHz spacing (preamp off) |
| Input impedance |
50 ohm (SMA connector) for each channel |
| Output impedance |
50 ohm (SMA connector) for each channel |
| Amplitude ripple |
3 dB typ. |
| Phase ripple |
3 degrees typ. |
| Channel-to-channel isolation |
>80 dB |
| Operating voltage |
12 V DC ±5% |
| Power consumption |
8 W typ. |
| Dimensions |
150 x 90 x 30 mm (5.9" x 3.5" x 1.2") |
| Weight |
330 g (11.6 oz) |
| Operating temperature |
-10º to +60º C |
| Humidity |
20-90% non-condensing |
WR-G527e/RMF Reference Oscillator and Distribution Module
| Total oscillator phase noise |
-115 dBc/Hz @ 10 kHz |
| Tuning speed |
5 ms typ. |
| Settling speed |
0.8 ms / MHz typ. |
| Frequency stability |
0.01 ppm |
| Operating voltage |
12 V DC ±5% |
| Power consumption |
12 W typ. |
| Dimensions |
150 x 90 x 45 mm (5.9" x 3.5" x 1.8") |
| Weight |
660 g (23.3 oz) |
| Operating temperature |
-10º to +60º C |
| Humidity |
20-90% non-condensing |
| * As a result of the heterodyne process, a small number of spurii exist
on certain frequencies (approx 6 frequencies in the entire 20-3000 MHz range),
which are above the typical -107 dBm level. No spurii exceed the -90 dBm level. |
Due to continuous product improvement, specifications are subject to change without notice. |
